Electrical

Electrical
Here You Will Find Electrical Parts For The TK Bedford Truck Models.
The TK was released in 1960 as a replacement for the relatively short lived S Type, it was built by Bedford into the 1980s and was built later by another company that purchased Bedford for a few years more. The TK was a very popular truck with everyone including the Army in the UK they were assembled in a few other countries including many in Australia being fitted with local Holden engines.
Brad Dunns Vintage Truck Supplies
 

Products

12 Volt Ignition Coil Screw in High Tension Lead Type with Silver Body. Original Classic Function & Style. 1935-65

Product code: BDVTS18297
If Having Your Vehicle looking very Original is very important, then this 12 Volt Coil is the what You Require- as it has the correct screw in Coil Lead Olive Fitted. Beautifully made to compliment your Classic Truck or Car.
$92.00
save 15%
including GST 10.00 %

Bedford Trucks, Van & Bus Distributor Condenser Capacitor.

Product code: BDVTS18121
If your truck has a problem with cutting out dead after warm up or runs roughly or if your points are burning out more than expected then your Condenser may be the culprit. These are unserviceable & impossible to diagnose by looking at. So at at tune up- change it, this way all bases are covered. Please check the list below to make sure this DELCO REMY style Condenser is right for yours.
$44.00
including GST 10.00 %

Brake Light Switch Push on spade terminals Morris Commercial, Austin, MG TD/TF

Product code: BDVTS18053
Brake Light Switch with spade Terminals for British Cars & Trucks.
$36.00
including GST 10.00 %

Brush Set Lucas Dynamo Generator British Cars, Trucks & Tractors. Austin, Bedford & More

Product code: BDVTS17961
Here's a new Carbon Brush set for the Lucas Generator. For proper fitment see Detailed description.
$39.00
including GST 10.00 %

Coil Lead Boot Angled Rubber Gaiter

Product code: BDVTS17903
A quality Angled Non resisted Ignition Coil Gaiter/ Cap. Suits Petrol Engined models with 6 & 12 volt Coils with push in terminals.
$6.90
including GST 10.00 %

Coil Lead Boot Staight Rubber Gaiter

Product code: BDVTS17904
A quality Non resisted Straight Ignition Coil Gaiter/ Cap. Suits Petrol Engined models with 6 & 12 volt Coils with push in terminals.
$5.00
including GST 10.00 %

Contact Points Set- Suit International truck C & D Line, Bedford 6 cyl. 300 cu. in. Brockway, Hupmobile & Diamond T With Bosch Distributors

Product code: BDVTS18036
These Very High Quality West German made Points are just the thing to get your Truck running tip top. See Below for Exact model Fitment-
$55.00
including GST 10.00 %

Contact Points Set- Two Piece Suit Bedford G.M.C. Mack Oldsmobile Trucks & Vauxhall, Chev, Triumph, Studebaker and Holden Torana.

Product code: BDVTS18107
New Ignition Contact Points Set to Suit Bedford Trucks, G.M.C., Mack, Oldsmobile Trucks & Vauxhall, Chev, Triumph, Studebaker Hudson, Buick, Vauxhall, Triumph, Nash, Packard, Pontiac and Holden Torana Cars See Below for proper fitment.
$38.00
including GST 10.00 %

Distributor Cap To Suit Delco Remy 6 Cylinder Vehicles

Product code: BDVTS17984
This Popular Delco Distributor Cap fits a lot of Trucks and Cars too. Please see Detailed description for Exact models it fits.
$74.00
including GST 10.00 %

Ignition Coil 12 Volt (Non-Ballasted) to suit Petrol Bedfords **12 VOLT**.

Product code: BDVTS17973
Ignition Coil 12 Volt (Non-Ballasted) to suit to suit LAND ROVER 1948- onwards
$68.00
including GST 10.00 %

Ignition Spark Plug Copper Lead Set suit Bedford TJ, TK, TD, C, E, M, N, VA & TF 6 cylinder 214 cu in. Petrol

Product code: BDVTS18134
Copper Wire Original style Bedford 214 cu in complete lead set for the *Delco Remy* Ignition. Made from quality Parts and Aussie assembled, this set is built to last well and perform, Will not suit ignition systems converted with Electronic ignition. * Doesn't fit Lucas Systems*
$109.00
including GST 10.00 %

Ignition Spark Plug Copper Lead Set suit Bedford TJ, TK, TD, C, E, M, N, VA & TF 6 cylinder 300 cu. in. Petrol Engine

Product code: BDVTS18269
Copper Wire Original style Bedford 300 c.i. complete lead set for the *Delco Remy* Ignition. Made from quality Parts and Aussie assembled, this set is built to last well and perform, Will not suit ignition systems converted with Electronic ignition. * Doesn't fit Lucas Systems*
$109.00
save 5%
including GST 10.00 %